Z3043X13 radial drilling machine

Maximum drilling diameter (mm) Cast iron 40 Steel 32
Distance from spindle end face to worktable (mm) 260-1150
Distance from spindle center to column busbar (mm) 360-1300
Spindle stroke (mm) 200
Spindle taper hole (Mohs) 4
Spindle speed range (r.p.m.) 75, 130, 240, 380, 660, 1200
Spindle speed level 6
Spindle feed range (r.p.m.) 0.10-0.25
Spindle feed magnitude 3
Swing arm rotation angle (°) 360
Main motor power (kw) 2.2
Lift motor power (kw) 1.5
Machine weight (kg) 1400
Dimensions (mm) 1800 × 810 × 2300

Z3043X13 radial drilling machine features:
1: This machine tool has automatic lifting, spindle automatic feed, mechanical locking, and mechanical variable speed. Electrical and mechanical double-layer protection.
2: The feed structure of the machine tool is equipped with a protective device, and the feed worm gear is equipped with a lubrication device.
3: This model of machine tool is divided into single column and double column models. The double column model has flexible rocker arm rotation and high work efficiency.
The Z3040X13 rocker drilling machine is composed of a chassis, columns, cross arms, spindle box, lifting box, work platform, etc. The arm of the rocker drill can wrap around the column
360 degree rotation and vertical movement along the column can reach a stroke of 1000mm. The spindle box can move left and right along the cross arm guide surface. Therefore, the main characteristics of the rocker drilling machine are strong applicability, wide applicability, and suitability for processing larger workpieces
The disadvantage of rocker drills is that due to the large number of joint surfaces, the rigidity and accuracy of the machine tool are slightly poor.
Z3040X13 Operating Procedures:
1. When processing, it is strictly prohibited to wear gloves, and the workpiece clamping should be firm. When drilling small parts, flat pliers or tool clamps should be used to clamp them, and the drill should not be held by hand.
2. When drilling on the machine, do not touch, flip, press or measure with your hands.
3. No one is allowed to stand within the rotation range of the arm of the rocker drill, and the arm should be tightly clamped.
4. Under the crossbeam and on the workbench, no debris or obstacles are allowed.
5. When using automatic cutting, adjust the limit block and manually feed without excessive force.
6. When there are long iron shavings on the drill bit, it is necessary to stop and use an iron hook to remove them. It is forbidden to blow or manually pull the rocker arm. The drilling machine mainly consists of a base, inner column, outer column, rocker arm, spindle box, and worktable
Disassembly sequence of main components of rocker drill:
(1) Cut off the power and remove all motors and related electrical components.
(2) Remove the spindle box from the right end of the rocker arm.
(3) Support or stabilize the rocker arm, and remove the lifting mechanism
(4) Lift out the rocker arm.
(5) Hang the outer pillar.
(6) Remove the inner pillar from the base.
(7) Remove the base (if it is repaired in place or does not require surface planing, it is not necessary to remove the foundation).