VDLSeries/Vacuum Oven with Special Safety Performance

Safely dry in the presence of flammable solvents. A set of extended safety features makes drying materials containing flammable solvents very safe. For the VDL series, the TUV quality mark is a standard requirement, and the internal chamber of the equipment meets the ATEX standard; Exll-13G CIIBT3-T1 GcX. As an option, the drying oven can be upgraded to operate in Class II explosion hazardous areas in accordance with EC Directive 94/9/EG (ATEX Directive), or inert gas can be used to replace and purify areas containing circuits.

• Performance characteristics and equipment

-Electronic controlled APT.line^®Internal preheating technology and two extended shelves

-Temperature range: from 15 ° C to 200 ° C above ambient temperature

-MS controller with cumulative timer (0 to 99 hours)

-Timer function of the controller: delayed opening, delayed closing, and temperature dependent delayed closing

-The slope function can be adjusted through a program editor

-Adjustable heat output (0 to 100%)

-Pressure monitor, heating release can only be activated when the pressure is less than 125 millibars

-Using compressed air to seal the instrument room against overpressure

-Fireproof lining

-Precise quantitative ventilation valve

-Adopting cross flow technology and precise inert gas quantitative supply valve

-Anti shatter safety glass panel with springs installed

-Simulated pressure gauge (displaying the pressure difference between the internal cavity and the surrounding environment)

-Inner cavity of electrolytic polishing

-All suction and ventilation pipes, as well as pressure vessels, detachable shelves, and vacuum valves welded internally, are made of stainless steel material 1.4571 (V4A)/AISI316 Ti

-The material of the door gasket is tempered silicone resin

-Independent adjustable temperature safety device, level 2 (DIN12880), equipped with a visual temperature alarm

-Rear with 16mm diameter measuring interface

-Used for communication software APT COM^®Printer and communication interface RS422 for data control system

All technical data is only applicable to 22±3 ° C ambient temperature±Standard specification unloaded equipment under 10% power supply voltage fluctuation. Determine temperature data according to BINDER factory standards and DIN12880:2007, and adapt to the recommended wall gap of 10% of the internal chamber height, width, and depth. For the device series, all data are typical averages. We reserve the right to modify the technology.