Manufacturer produces and sells electric flat vulcanizing machine XL-8122B2 experimental hydraulic flat vulcanizing machine

Overview

flat vulcanizing pressSuitable for high molecular weight polymer materials such as rubber, plastic, resin, etc., the raw materials are placed in a dedicated mold and sandwiched between electric heating plates to form the raw materials for testing. Suitable for laboratory development in research institutions, universities, and enterprises.
This series of machine templates has an upward pushing force and a designed maximum capacity of 20-100 tons (customer selection).
Experimental typeflat vulcanizing pressEquipped with electronic intelligent instruments to control the molding action, it can set the molding pressure, molding temperature, molding time, and molding electricity
There are two automatic operation modes for the hot plate to rise or fall, with low noise.
This machine has a dedicated electric hydraulic system with automatic pressure compensation, automatic pressurization and depressurization. The oil cylinder has high precision, high wear-resistant guide column, strong load force, and smooth lifting.
Using imported specialized heating wires, high-precision and stable temperature sensors and thermostats, the temperature range is controllable from room temperature to 300 ℃.
Using imported electric heating plate materials, high carbon steel flat precision grinding, quenching, and surface hard chrome, it has high temperature resistance, corrosion resistance, fast heat transfer, and is not easily deformed.
electricflat vulcanizing pressThe temperature controller independently controls the temperature of the upper and lower heating templates, with independent temperature display. The timer controls the time, and when the time is up, the heating power is cut off. It can also be used separately without the timer, with completely user-friendly operation.

Main technical parameters
1) Structural type: Four column, electric electric heating hydraulic type.
2) Template upward push force capacity selection: 20T, 25T, 35T, 50T, 63T, 100T (optional, standard model 25T).
3) Thermostat: Range from room temperature to 300 ℃, can be set arbitrarily (upper mold, lower mold).
Imported LED electronic display, temperature control mode P.I.D self-tuning mode, combined with high-precision sensors, with automatic temperature compensation and equalization function.
4) Timer: Intelligent dual digital display measuring device, LED 0~99 min~9.9hr (factory set to 9999 min).
5) Panel oil pressure gauge: controls the pushing force of the upper/lower template. The push force of this machine can be set, and the test force can be adjusted.
6.1) One set of mold combination plate (mold plate square hole: 250 X 250mm, can be used to combine thicknesses of 1.0, 2.0, and 3.0mm),
6.2) Template protection plate (electric heating lower plate and cooling lower plate): 365 X 365 X thickness 2.0 mm, two pieces.
7.1) Heater and method: Electric heating, imported heating element.
7.2) Working layers of pressure plate: In the two-layer area, the upper molded plate is heated and the lower molded plate is cooled.
7.3) Mold opening method: fully automatic up or down.
7.4) Electric heating pressure plate (upper layer): 360~600 mm optional (standard 360 X 360mm).
Cooling pressure plate (lower layer): 360~600 mm optional (standard 360 X 360mm).
7.5) Electric heating plate or cooling plate: The plate spacing is 0-80mm, or ordered separately.
7.6) Cooling method: Standard forced air cooling (tap water cooling or specialized test oil cooling, optional).
7.7) Safety protection plate device: not used as standard (customer optional).
8) Power supply: 3 ∧/AC/380V, three-phase five wire system wiring.
9) Volume: Approximately 1200 × 600 × 1650mm.
10) Weight: Approximately 1100KG.

Picture of our manual flat vulcanizing machine