Product Introduction

Portable fuel sniffing device

1、 Introduction

Portable fuel sniffing deviceThe FDM6000 was jointly developed by Spaghetto Technologies and the US Navy. It uses surface acoustic wave sensor technology to detect the fuel content in lubricating oil by detecting the "vapor in the headspace" of the oil sample bottle. Its function is to monitor the pollution status of fuel in engine oil.

The fuel sniffing device is designed and developed based on the "Henry's Law": the concentration of fuel vapor is directly proportional to the amount of fuel present in the lubricating oil.
The built-in sampling pump of the fuel sniffer transmits fuel vapor to the surface acoustic wave sensor, which determines the content of hydrocarbons (the main component of fuel) based on its frequency changes.

2、 Fuel dilution

Fuel dilution: Incomplete combustion of fuel under high pressure can enter the crankcase through the piston rings and contaminate the engine oil.

（1） Reason for occurrence:
1. Frequently started internal combustion engines;
2. Excessive idle running and low-temperature operation;
3. Incomplete combustion+fuel system leakage;
4. Research has shown that diluted fuel accounts for approximately 0.36% of total fuel consumption.

（2） Harmfulness
1. Diesel dilution during operation under low temperature conditions can form wax, which can cause a decrease in oil pressure and even lean fuel during start-up;
2. Unsaturated aromatic hydrocarbons in fuel are oxidants that cause a rapid decrease in base value, thickening the oil and obstructing its flow, resulting in lean fuel;
3. Reduce viscosity, such as changing 15W40 to 5W20, which will thin the oil film and increase the wear of piston rings, cylinder liners, and bearings;
4. The leaked fuel will wash away the lubricating oil on the cylinder wall, accelerate the wear of piston rings and cylinder liners, and cause blowby, resulting in increased fuel consumption;
Reduce the effectiveness of additives;
5. The problems caused by biofuel diesel engines are more serious, such as oxidation stability, clogged filter screens, formation of sediment, and accumulation of crankcase caused by evaporation.

3、 Main features

1. Only one calibration curve is supported;
2. Fast analysis speed (about 1 minute) and accurate results (10% of measured values);
3. Low usage cost, no need for chemical reagents or other consumables.