VIP member
Product details
There is a WeChat QR code below the homepage of the official website. Adding a QR code allows you to watch device videos
Sales Department 1:
Email:
Tianma and Poria are two precious Chinese medicinal herbs with a large cultivation volume nationwide, which rely on honey fungus as their nutritional source. However, in the production of Tianma and Poria, honey fungus must be produced first, and preparing the raw materials for honey fungus production -2-3 centimeter long slanted short branches - is a very heavy physical labor. Zhengzhou Bochao Machinery, at the request of customers, finally developed the "Honeycomb Branch Machine" in 2014, which will replace the heavy physical labor of cutting short branches. The processed branches have consistent length, smooth cross-section, and high efficiency. They can process 0.1 tons of branches per hour, which is 15-20 times that of manual cutting.
Precautions for use:
1. The diameter of the oak branches used for cutting should not exceed 2 centimeters, and the lateral branches should be removed to make them as single as possible.
2. Fresh branches should be cut as soon as possible after cutting, and dried branches should be soaked in water for 2 days before cutting to reduce cutting resistance.
3. Sharpen the knife every 2 hours of work to keep the blade sharp at all times. When sharpening a knife, only one side can be sharpened and not both sides.
4. Every few minutes during work, use an iron milling shovel to remove the accumulated branches at the discharge port, otherwise too many branches may cause blockage and knife failure.
5. Sometimes, if there are too large knots on the branches, the machine may be suffocated (the blade is stuck in the cutting edge by the branch and cannot be moved). At this time, the power switch on the table should be immediately disconnected, and then the clamping knife round iron should be reversed to release the suffocated state.
competitive advantage
|
|
||||
|
|
working principle
Insert a branch with a diameter of about 3cm into the feeding port, use a high-speed blade to cut the branch into 2-5cm branches, and then exit from the discharging port. The length of the cut branches is adjustable, ranging from 2-5cm for you to choose from!Technical Specifications
| model | power | Number of blades | output |
| 400 type | 3kw | 1 piece | 200-400kg/h |
Online inquiry
-
Contacts
-
Company
-
Telephone
-
Email
-
WeChat
-
Verification Code
-
Message Content
-