Structure: Forced mixer, consisting of material cylinder, frame, motor, reducer, rotating arm, mixing shovel, cleaning scraper, etc Due to the use of a cross axis assembly between the mixing shovel and the rotating arm, and the setting of a pull rod or screw to regulate the working clearance of the mixing shovel, the phenomenon of hard materials getting stuck can be basically eliminated, thereby reducing operating resistance and wear. The working face of the mixing shovel has an obtuse angle with the forward direction in both vertical and horizontal directions, which can enhance the mixing effect and improve the mixing quality. The discharge port is located on the side wall of the material cylinder, which can swing laterally relative to the frame. A cleaning scraper is also installed to accelerate the discharge and make it more thorough, while reducing mud leakage. Drive scheme: The motor and transmission mechanism are placed below the mixing drum; Drive directly with a cycloidal pin reducer. The safety during use has been guaranteed, avoiding the occurrence of some accidents.

Usage: 1. General usage: After the mixer is powered on, start the main mixing motor through the start (stop) switch with protection function. When the equipment enters normal working state, add the substance to be mixed into the mixing tray of the mixer. At the same time, add a certain amount of water to the mixing tray through the water pump and mix together. After the material is evenly mixed, open the material door to discharge. After all the materials in the mixer are discharged, close the material door to complete one mixing cycle. The water supply adopts 220V750W single-phase submersible pump, timed water supply, and automatically shuts off and stops water supply after the water supply time is completed. The entire process of adding water is simple and easy to operate.

2. After the mixer is powered on, start the main mixing motor and enter normal working state. Then add the amorphous refractory material into the mixing tray of the mixer. At the same time, add a certain amount of water to the mixing tray through the water pump and mix together. After the material is evenly mixed, open the material door and enter the trolley through the discharge chute. The trolley can move and stay freely on the working guide rail to meet the feeding needs of different positions of the main iron hook. After all the materials in the mixer are discharged, close the material door to complete one mixing cycle. During work, a certain gap should be maintained between all scrapers and liners. The water supply adopts a 220V750W single-phase submersible pump, timed water supply, and automatic power-off after the water supply is completed.

Technical Specifications: