Introduction to Packaging Samples

The N95 mask packaging machine is suitable for packaging individual N95 masks, activated carbon masks, and KN95 masks. The sealing form of the machine is back sealing, and the bag form is serrated and easy to tear. Basically, the commonly used bagged masks can be packaged using this machine, which conforms to the common mask packaging methods in the market.

From the following picture, we can see the effect of the suction type mask packaging machine, which uses a vortex air pump to extract the air from the bag, so that the entire mask product does not swell and bulge so much. This is also beneficial for packing and stacking

The suction type mask packaging machine is a newly developed automatic mask packaging machine by our company for single packaging of disposable masks, flat masks, N95 masks, and KN95 masks. The machine uses a vortex air pump to extract air from the bag to achieve a vacuum state. This machine has higher exhaust efficiency than traditional sponge exhaust. Sponge exhaust is usually replaced after a week of use, and this machine will no longer use sponge exhaust.

Product Introduction

The operation process of the machine is as follows: the operator manually puts the disposable masks, flat masks, N95 masks, and KN95 masks that need to be packaged into the tray conveyor belt, and then the conveyor belt transports the masks to the packaging machine. Then, in conjunction with the vortex air pump, gas is extracted during the bag sealing process, and the packaging process is completed through a series of steps such as film rolling, bag making, and sealing

This suction mask packaging machine is equipped with intelligent chips, metering, and automatic detection of electrical faults. It is easy to operate and adjust. This machine can also be set and cut according to the bag length in one step, saving labor and film. On average, packaging 80-100 products per minute is cleaner and more hygienic than manual packaging.

Product parameters

Detail Display

1. The suction type mask packaging machine is equipped with a conveyor belt made of 304 stainless steel, which will not rust and effectively ensure that the material will not produce pollution. Customized metal bag makers can be made according to the specific mask form of the customer.

2. This mask packaging machine is different from the previous ones. The previous ones added sponge in the end sealing cutting area for exhaust treatment, while this one adds a vortex air pump in the hot sealing area for exhaust treatment. Traditional sponge exhaust requires replacing the sponge once a week. With this device, there is no need for a sponge anymore, resulting in higher efficiency. The roll film is transported by the upward film method, which is convenient for hanging and easy to adjust.

3. The high-strength and hard material is used to create the end seal cutting area, and the air extraction device is used in this process. After the gas is extracted, the middle seal is sealed, and then it enters the end seal cutting area. The equipment automatically detects the cutting, and the packaging film will not stick to the cutting blade, which extends the service life of the cutting blade and does not waste the packaging film. After being cut in the cutting area, the finished product is directly transported by the conveyor belt to the box for packaging.

4. Electronic display touch screen control, convenient and fast parameter setting, PID independent temperature control system for temperature control of end and middle seals, both independently control temperature without interference with each other. A brush is installed at the exit of the end seal cutting area to transport materials and prevent them from getting stuck at the end seal. The material is then transported by a conveyor belt to the box for packaging.