The electric film winding device has a large film winding length of 100m, and the drive shaft adopts a thin-walled galvanized pipe with a diameter of 25 * 1.5.

Electric film rollers have the characteristics of light weight, high output torque, output self-locking, high stroke adjustment accuracy, large adjustment range, rain and dew prevention, and low power consumption. They are suitable for use in different climatic conditions and are the best choice for modern solar greenhouses.

How to install an electric film roller?

1. Drive the steel pipe to extend about 150mm from one end of the greenhouse installation film roller and cut it without bending or twisting.

2. Use M8 hex screws to connect the joint of the drive shaft to the drive steel pipe.

3. The overlap length between the expansion pipe (outer) and the expansion pipe (inner) shall not be less than 100mm of the roll film width.

4. The telescopic pipe (inner) and the fixed pipe should be able to rotate around the fixed steel pipe after being hinged.

5. The side opening electric coil climbing steel pipe and the driving steel pipe should form a right angle.

The use of electric film coiler:

1. During transportation and installation, prevent falls and bumps on the electric film roller.

2. It is strictly prohibited to exceed the output torque range of the electric film roller.

3. If the user discovers a malfunction in the electric film winding device during use, please do not disassemble the film winding device body by yourself.

Scope of application of electric film winding device:

Electric film rollers are used for opening and closing the side and top windows of plastic film greenhouses, replacing traditional manual film rollers to achieve automatic control of film rolling, unwinding, and greenhouse environment.