The dual machine linkage bending machine is a machine capable of bending thin plates, with a maximum opening height of 450mm. Its structure mainly includes a bracket, a worktable, and a clamping plate. The worktable is placed on the bracket, and the worktable consists of a base and a pressure plate. The base is connected to the clamping plate through a hinge. The base consists of a seat shell, a coil, and a cover plate. The coil is placed in a recess of the seat shell, and the top of the recess is covered with a cover plate.

Working principle of dual machine linkage bending machine:

The hydraulic bending machine includes a bracket, a worktable, and a clamping plate. The worktable is placed on the bracket, and the worktable consists of a base and a pressure plate. The base is connected to the clamping plate through a hinge. The base consists of a seat shell, a coil, and a cover plate. The coil is placed in a recess of the seat shell, and the top of the recess is covered with a cover plate.

When in use, the coil is energized by a wire, which generates an attractive force on the pressure plate, thereby achieving the clamping of the thin plate between the pressure plate and the base. Due to the use of electromagnetic force clamping, the pressure plate can be made into various workpiece requirements and can also process workpieces with side walls. The bending machine can meet the needs of various workpieces by replacing the bending machine mold.

Product features of dual machine linkage bending machine:

Select two WC67K series hosts of the same specifications and configure a dual machine linkage synchronization device.

Two machine tools can be linked to process extra long workpieces.

Two machine tools can also be used separately at the same time to improve production efficiency, equipped with a deflection compensation mechanism.

The synchronization mechanism adopts mechanical hydraulic servo and mechanical stopper.

The stroke of the upper slider and the position of the rear stop material rack are adjusted quickly by motorized means, with manual fine-tuning and electronic numerical control display.

Usage of dual machine linkage bending machine:

A brief introduction to processing Q235 sheet metal using a regular hydraulic bending machine:

1. Firstly, connect the power supply, turn on the key switch on the control panel, and then press the oil pump to start.

2. Travel adjustment: When using a bending machine, attention should be paid to adjusting the travel, and a test drive should be conducted before bending. When the upper mold of the bending machine descends to the bottom, there must be a gap of plate thickness. Otherwise, it will cause damage to the mold and machine. The adjustment of the itinerary also includes electric quick adjustment and manual fine adjustment.

3. When selecting a bending groove, it is generally necessary to choose a groove with a width 8 times the thickness of the board. If bending a 4mm sheet metal, a slot of about 32 should be selected.

4. Rear gear adjustment generally includes electric quick adjustment and manual fine adjustment, using the same method as a shearing machine.

5. Press the foot switch to start bending. Unlike the shearing machine, the bending machine can be released at any time. Release the foot switch to stop the bending machine, and then press it again to continue the downward movement.