1HH-S8S digital constant temperature constant speed magnetic stirring water bathCharacteristics and Applications:

HH-S8 digital constant temperature constant speed magnetic stirring water bathIt is a product customized according to customer needs,Advantages of a general constant temperature water bath: The inner pot is made of stainless steel plates welded together，The shell adopts cold plate spray coating, which improves the anti-corrosion ability of the whole machine.Temperature control adopts pen segment LCD display, blurryPIDControl, high temperature control accuracyMagnetic stirring adopts digital speed measurement,8 sets of constant speed devices,8Equipped with a brushless motor, the mixer can work continuously for a long time (without cutting off water or heating)Ideal equipment for laboratory staff.

IIHH-S8S digital constant temperature constant speed magnetic stirring water bath

1. Power supply: 220V, frequency 50HZ

2Working Size：605×310×120mm

External dimensions:104.5×38×550px

3. Heating power: 2000WMixing power: 45W (8 sets of brushless motors)

4. Temperature control range: room temperature+5—100℃，Temperature control accuracy:±0.5℃

Speed control range: Start~2400 rpm, speed control accuracy: ± 1 rpm

5. Temperature control timing range: 0~9999 minutes,Mixing timing range：0~999minute×8 groups

IIIusage method:

Firstly, inject pure water into the pot, with the water level being 3CM higher than the heating tube.

1Speed setting:support8Place each beaker separatelyHeating pipeIn the middle, place the stirrer into the beaker,Turn on the power switch and the indicator light will turn on. Press the "∧" key to display an increase in speed, and press the "∨" key to display a decrease in speed. After setting the speed, press the "RUN" button to start the motor, and press the "STOP" button to stop the motor.

Press and hold the up and down keys on the right to set the time, press the "∧" key to increase the time, and press the "∨" key to decrease the time.

Set the time before the motor starts running. The motor is running and the set time is invalid.

The up and down keys on the left side of the display panel are for speed setting, and the up and down keys on the right side are for time setting.

2Temperature setting:

Please refer to the user manual of the LCD thermostat controller.

4、 Attention:

1This product uses 220V AC power, and the power input is a three pin plug. The grounding wire should be properly grounded to ensure.

2. It is not advisable to add too much water to the pot to prevent the water from overflowing when boiling. However, a low water level should not expose the heating tube to the water surface to avoid burning it out.

3This instrument needs to be supervised by a dedicated person during operation to avoid accidents!

4Clean the instrument thoroughly after use and cut off the power supply.

Our factory's products:

(In addition to the following products, our factory can also customize instruments according to customer needs. Consultation)

Series of incubators, series of gas bath and water bath constant temperature oscillators, series of speed regulating multi-purpose oscillators, series of magnetic stirrers, electric stirrers, series of water bath pots, sand baths, water tanks, centrifuges, series of crushers, grinders, homogenizers, series of stainless steel electric heating plates, lifting tables, constant temperature plates, series of quartz sub boiling and stainless steel distilled water dispensers, series of electric furnaces, constant temperature carriers, series of analytical instruments.