Chongqing Centrifuge, Chongqing Industrial Centrifuge, Chongqing Industrial Dehydrator, Xinxiang Hengxin General Equipment Co., Ltd

Manager Qi from Changshou District, Chongqing and Manager Cui from Huaxian County, Hebi respectively ordered1platformSS1200Centrifuge

On November 1, 2014, Manager Qi from a chemical industry company in Changshou District, Chongqing, and Manager Cui from Huaxian County, Henan, respectively ordered one SS1200 three legged centrifuge from our company on November 7. The machine from Changshou District, Chongqing was shipped out through the freight department on November 6, and Manager Cui's machine from Huaxian County has been arranged for production and is expected to be shipped out in 3-5 days.

The SS1200 three legged centrifuge has an inner diameter of 1200mm, a large capacity of 250 kilograms, a motor power of 11kw, a speed of 800 revolutions per minute, a total weight of about 2000 kilograms, and an outer shape of about 2000 * 1800 * 1200.

40setSS1000Centrifuge brake pad ordering news

On August 18, 2014, Manager Chen from Chongqing ordered 40 sets of SS1000 tripod centrifuge brake pads from our company.

Centrifugal brake pads, also known as centrifugal brake pads, centrifugal friction pads, three legged centrifugal brake pads, etc，Centrifugal brake pads are the main components of the three legged centrifugal brake system,Fixed on the brake ring, each centrifuge has 4 brake pads.

Structural characteristics of centrifuge
1. Industrial centrifugal dewatering machines are all equipped with a three legged suspended pendulum structure, which can effectively reduce the foot vibration caused by the unbalanced load inside the hub during operation.
2. The shell and top cover are made of high-quality stainless steel, the cage base and chassis are made of cast iron material, and the water outlet pipe is located below the chassis.
3. The spindle is made of high-quality steel that has undergone heat treatment and precision machining.
4. The transmission part adopts triangular tape transmission, and the centrifugal starting wheel is directly driven by the motor, which can slowly start the machine and gradually reach the design speed to ensure smooth operation of the machine.
5. There is a brake opening and closing arm inside the machine, which has good braking performance and can quickly stop the machine.

Centrifuge operation method

1Place the machine on a level surface, ensuring that the ground is level and even. The power connection method is delta connection. After connecting the power, test the machine once to ensure that the inner container rotates clockwise.

2Place the filter bag inside the inner container, lay it flat, and ensure that the filter cloth is tightly attached to the inner container wall.

3Place the material that needs to be dehydrated evenly and smoothlyInner linerInside, pay attentionsmoothUniformThe loading amount is strictly prohibited from exceeding the machinerelativelyLarge capacity.

4Start the machine and wait for about 30 seconds for it to reachrelativelyHigh speed, if the machine vibrates significantly during this process, immediately disconnect the power and check if the material is flat and uniform. The machine has reachedrelativelyAfter high-speed operation, a large amount of liquid is discharged from the drainage pipe. After about 2 minutes, the material is basically dry and there is almost no liquid flowing out of the drainage pipe. The power can be turned off. After 1 minute, apply the brake and do not brake it all at once.

5After the machine comes to a complete stop, remove the material and re lay the filter cloth in the inner tank to proceed with the next dehydration process.

6Never put materials into the machine during operation to prevent the high-speed rotating drum from throwing materials out and injuring people.The brake should not be applied all at once, but should be applied several times to stop the machine.