Henan manufacturer of sterile stainless steel storage tanks

The device consists of an inner liner, jacket, insulation layer, outer sheath, reducer, mixing blade, thermometer, etc.

1Inner liner: made of stainless steel plate304Made of materials and polished on the surface.

2Middle jacket: usingA3Steel plate or1Cr18Ni9TiMade of steel plate and reinforced with a spiral device, the cold water flows from bottom to top (without pressure) to achieve optimal heating and cooling.

3Insulation group: It is made of stainless steel plates thrown into fish scale patterns, and the insulation layer is made of polyurethane or glass wool to maintain the temperature with the outside world, achieving the insulation effect.

4Reducer: Cycloid pinwheel planetary reducer, fixed on the bracket in the crossbeam, the reducer wheel output shaft is connected to the mixing blade, using a loose coupling for easy disassembly and cleaning.

5Temperature gauge: specifications00C~1000CInstall on the crossbeam, extend straight to the lowest position of the medium, so that the liquid material can indicate the temperature even when it reaches the lowest position, achieving the purpose of sterilization and aging.

Installation:

Adjust the support legs of the device to a horizontal line perpendicular to the reducer before installing each pipeline. During operation, be sure to rotate the mixing blade clockwise and not in reverse.

Usage and maintenance:

1Explanation: Before using this device, the liquid storage tank must be cleaned with hot water and then disinfected with steam. The material slurry enters the cylinder through the material pipe fixed on the cylinder head, or is poured into the cylinder head when the cylinder head is opened. The material should not be filled too full to avoid splashing out when the material is stirred by the mixer, causing unsanitary environment or loss.

2Heating method: When heating, the refrigerant inlet valve must be closed, the remaining refrigerant in the jacket must be drained, and then the material should be input. The mixer should be started, and then the steam valve should be opened. After reaching the desired temperature, the steam valve should be closed first2~3After minutes, turn off the mixer again.

3Cooling method: Close the steam valve, drain the remaining steam condensate from the jacket, and then open the cylinder bottom refrigerant valve to allow the refrigerant to pass through the jacket and reduce the temperature of the material inside the cylinder.

4Insulation: According to the required temperature, start the mixer, high-speed valve, and maintain the temperature (pay attention to the temperature gauge) to achieve insulation.

5Cleaning: After the processing is completed and the remaining condensed water in the jacket of the cylinder is drained, it should be rinsed with warm water as soon as possible to brush off the sticky material, and then used40C~50CThoroughly clean the inner wall of the container with alkaline water and rinse with clean water. For the next use, use hot water or steam（90C）Above, maintain2~3Minute disinfection treatment.

6Maintenance: Regularly pay attention to the working condition of the entire equipment and reducer. If the lubricating oil of the reducer is insufficient, it should be replenished immediately and the oil should be changed every six months（40#When the equipment is not in use, it is necessary to rinse the jacket with warm water to prevent salt water corrosion. The cylinder body should be cleaned regularly to keep the surface clean and the inner liner bright, achieving the purpose of durability.

Main overall dimensions