1、 TC-601L Hard Soil Slime Soil Sampler Product Introduction:
Convenient, fast, and accurate collection of soil samples, maximizing control of sampling errors, in accordance with the regulations issued by the Ministry of Agriculture“Land fertility survey and quality evaluation project for cultivated land”In practice, the latest soil sampler has been developed. The use of this sampler for collecting soil samples has the advantages of being full layer, equal amount, fast, and easy to operate.
The most commonly used sampler at present is for soil testing and formula fertilization, and its standard is:
1Hard soil sampler: length700mm.external diameter30mminternal diameter25mm.Ruler300mmUltra hard stainless steel opening,Reciprocal screw in type, reverse sampling, sampling depth150mmabout1kgSoil sample
2Mud sampler: square push out type, length400mmThe cross-section is19mm×19mmSampling depth150mmabout1kgSoil sample.
2、 TC-601L hard soil and thin mud soil sampler usage method:
1、Hard soil sampling: usingTType sampler, place the sampler vertically downwards, hold the handle with both hands and rotate it back and forth, while pressing down (the force should be even, depending on the shear strength of the soil to maintain the natural condition of the soil). After that, lift the sampler out, with the outlet (the end with the handle) facing the sample inlet. Use the index finger to gently press on the soil inlet end, and the soil sample will slide out smoothly. However, if the soil is too dry, fine soil particles may clog the sampler during rotation, and the sample cannot be released smoothly. You can use a rubber hammer (equipped) to gently tap it to release the sample. If the soil is too sticky, it will stick to the sampler. In this case, a lining adhesive should be placed on the inner wall and taken out together with the lining adhesive when sampling.
2Sampling of mud: Use a linear sampler to pull the push rod to the appropriate position (usually150—200cm）Insert the sampler straight into the mud, rotate it until it is in place, fill the sampler with soil (mud), and then lift it up. Align it with the sample bag and use a push rod to push the sample out.