The equipment is mainly composed of iron materials. When abnormal wear occurs, it will definitely cause a significant increase in abrasive particles, leading to an increase in the concentration of ferromagnetic particles. FerroCheck2000 is equipped with a high-sensitivity magnetic sensor that can detect the concentration of ferromagnetic particles at the micrometer to millimeter level within 30 seconds, quickly reflecting the severity of equipment wear. At the beginning of equipment failure, discovering equipment abnormalities can prevent greater losses.

The detection accuracy of oil spectrometers is limited by the size of abrasive particles in the analyzed oil sample. When the particle size exceeds 3-8 microns (with varying degrees of restriction for different elements), the reliability of the analysis results of traditional oil spectrometers decreases. But for some heavy equipment, such as large gearboxes and bearings, they will produce approximately 10um of abrasive particles in the early stages of wear. It is obvious that the traditional oil spectrometer has significantly reduced its ability to monitor this wear state.

Product Features

FerroCheck 2000 meter detects the content of ferromagnetic particles in lubricating oil and hydraulic oil in use

The total amount of ferromagnetic particles in lubricating oil is one of the most direct indicators to characterize the degree of wear and equipment failure of controlled equipment. By measuring the concentration of ferromagnetic particles in the oil on site, the abnormal wear degree of the equipment can be quickly identified.

FerroCheck detection principle: When the oil sample enters the sample cell and flows through the magnetic induction coil, the magnetic induction of the FerroCheck detection coil changes.

Main functions

Simultaneously meet the usage needs of industrial sites and oil monitoring laboratories.

Industrial site monitoring (equipment inspection and spot check)

1. Rapid quantitative determination of the total amount of large-sized ferromagnetic particles in equipment oil
2. Suitable for monitoring the wear status of all oil using equipment

Oil Monitoring Laboratory

1. High detection accuracy, fast monitoring speed, suitable for all tested oil samples
2. No need for sample pretreatment, no need for organic solvents