To extend the service life of Shanxi desulfurization tower equipment, it is very important to use Shanxi dust removal and desulfurization tower correctly, as well as to inspect and maintain Shanxi dust removal and desulfurization tower. Only in this way can we extend the service life and operation time of our desulfurization tower equipment. The correct usage and maintenance methods are as follows:

1. During the operation of the desulfurization tower, the airflow inside the body will form vortices. Once vortices are formed, they are almost impossible to eliminate, especially when encountering changes in the temperature and velocity of dusty gases, as well as possible condensation on the pipe wall. Regular cleaning of the dust removal pipeline is necessary.

2. The cover plate of the cleaning hole and the wall of the desulfurization tower should be tightened with bolts or other clamping devices, and there should be rubber plates or rubber bands as pads between the cover plate and the dust collector.

3. The cleaning holes of the desulfurization tower should be located on the side or upper part of the pipeline, and all cleaning holes must be tightly sealed without air leakage.

4. The difficulty of operation and management is high, the water level is difficult to control, the dust removal effect cannot be achieved when the water level is low, the water intake of the induced draft fan is high, and the acid-base neutralization is difficult to control.

5. Due to the high steel consumption per unit of the desulfurization tower, a better method for installation is to gradually increase the material thickness from the upper part of the cylinder downwards! This is easier to maintain.

The use and maintenance of desulfurization tower equipment are equally indispensable, and the normal operation of desulfurization tower equipment cannot be achieved without the careful daily maintenance work of the staff and regular cleaning of the desulfurization tower.

The position of the cleaning holes in the desulfurization tower should be on the side or upper part of the pipeline, and all cleaning holes must be tightly sealed without air leakage. If there is air leakage, it will reduce the flow velocity in the upstream pipeline of the cleaning holes, cause more serious dust deposition, and reduce the amount of air extracted from the suction holes. Pay attention to these details, as they determine success or failure. Small screws can lead to major accidents, so don't overlook small issues.