1. The DNC-2040DT machine tool is a multifunctional small drilling and tapping machine that integrates milling, drilling, tapping, and chamfering;

2. The numerical control system is integrated with the machine tool, and the operator can operate on the numerical control system while observing the working condition of the machine tool. Moreover, due to its open structure, it can be processed at multiple workstations, with an effective processing length of 2000mm for the X-axis, 400mm for the Y-axis, and 200mm for the Z-axis; The spindle of the machine tool can move freely in X, Y, and Z directions, and manual labor only needs to change materials back and forth, thus forming a non-stop cyclic machining.

3. The machine tool adopts high-strength mechanical spindle, and the dual spindle can accommodate 2 different specifications of cutting tools

4. The machine tool adopts a CNC numerical control system and an open structure, which can perform multi station non-stop cyclic machining

5. The semi enclosed protective cover of the machine tool ensures the safety of the operator and environmental hygiene

6. We can customize non-standard size specifications and main component brands according to customer requirements

1. Power on: The shutdown interval should be at least 10 seconds, and do not switch on and off continuously (overcharging the frequency converter can damage it).

2. Shutdown: The X and Y axes must be manually moved to the center.

3. After turning on the device, make sure to perform the 'reset to zero' action.

4. When the water spray decreases, it is necessary to supplement the cutting water (water free idle water pump is prone to burning out).

5. When installing the clamp, it is necessary to ensure that it is stuck, and the surface and installation hole of the clamp should be cleaned thoroughly (otherwise it may damage the clamp and spindle body/tilt).

6. It is best to place the machine in an air-conditioned room or a well ventilated and dry place (air conditioning should not blow directly onto the controller).

7. The electrical parameters inside the control box shall not be adjusted arbitrarily.

8. The internal parameters of the controller must not be arbitrarily changed.

9. The workbench cannot be struck with a hammer, otherwise it will damage the flatness of the workbench.

10. Equipment usage environment, it is best to avoid direct sunlight and other thermal radiation, and to avoid places that are too humid, have too much dust, or have corrosive gases. The equipment should be placed in an air-conditioned room, and the air conditioner should not blow directly onto the controller.

11. Good power supply guarantee. To avoid large fluctuations in power supply and possible instantaneous interference signals, it is recommended to install voltage stabilizing devices or use dedicated power supply.

12. The equipment should not be stored for a long time. After purchasing the equipment, try to make full use of it. If there is no processing demand, the equipment can be powered on for about 1 hour per week~