Micro liquid filling equipmentMainly applicable to the packaging process of liquid filling in industries such as pharmaceuticals, oral liquids, beverages, health products, food, etc. This machine adopts automatic bottle feeding, disc positioning filling, capping, and screw capping, with a reasonable design; Adopting imported Italian Haiba pump for quantitative filling, with accurate measurement, especially suitable for filling liquid medicine in 0.2ml-1ml bottles; Needle made of 316L stainless steel material; The workbench is protected by stainless steel material, and the whole machine meets GMP requirements. The transmission of this machine adopts mechanical transmission, which is accurate and stable, without air source pollution or errors in the coordination of various mechanisms. When working, the noise is low, the loss is low, the work is stable, and the output is stable. It is particularly suitable for small and medium-sized production and can be purchased with protective covers!

The equipment is an automatic quantitative liquid dispensing machine designed with an electric, crank, and piston structure, suitable for quantitative filling of hospital preparation rooms, ampoules, eye drops, various oral liquids, shampoo, and various water agents; It can also be used for quantitative continuous liquid addition in various chemical analysis experiments, especially suitable for liquid packaging in large, medium, and small pesticide factories.

Equipment features
1. The power adopts a fixed set gear transmission and an electronic speed regulating motor, which runs smoothly and has low noise. The speed can be continuously adjusted.
2. Good metering pump with an accuracy of ± 0.5ml
3. The filling volume ranges from 1-1000ml, and filling can be achieved by selecting the corresponding specification filling machine. The machine is lightweight and can be placed freely. The filling volume can be finely adjusted to meet different user requirements.
4. Power supply: 220V
5. Simple structure, reliable, and few faults;
6. Adopting a conical piston, it has good sealing performance, accurate dispensing volume, and easy adjustment of liquid volume;
7. The liquid contact parts are made of stainless steel and are easy to install and unload, allowing for sterile dispensing;
8. The cylinder, push rod, and piston are made of stainless steel material, which is corrosion-resistant and wear-resistant;
9. The speed is continuously adjustable and easy to operate.

Micro liquid filling equipmentUsage
1. Before the machine starts working, the ground wire must be properly grounded, and then the appropriate standard injector should be selected according to the different packaging quantities. When the general packaging range is 0.2-1ml, a 1ml syringe is used; Use a 5ml syringe for 1-5ml; When 5-10ml, use a 10ml syringe; 20ml model, using a 20ml glass enema device; The 100ml model uses a 100ml glass enema device (or the stainless steel filling system produced by our factory can also be used); The 500ml model uses the stainless steel filling system produced by our factory.
2. For DLG-10, 20, and 100ml models, remove the syringe core ① and place the screw sleeve ② onto the syringe core (note: for 10ml models, due to the large difference in syringe diameter, gaskets need to be selected according to their outer circle size), and use the screw sleeve ② to properly fasten it to the lower base ③ (cleaning must be paid attention to when disassembling the syringe).
3. Insert the upper clamp seat ① onto the outlet end of the syringe sleeve ②, and tighten the nuts on both sides appropriately (when using a 5ml syringe, tighten the sleeve together, being careful not to tighten too tightly, as the outer sleeve is fragile). Note: The 10ml model comes with an adjustment sleeve, while the 20, 100, and 500 models do not.
4. Assemble the assembled syringe core and outer sleeve into one unit, and the injection system is now fully assembled.