type number:MV-19E/MV-25E

article Card:KOHAN KOGYO

give birth to Location: Japan

machine Heavy:3.8kg

Tightening force:2800N

Width of plastic steel strip:MV-19E：13mm-19mm

MV-25E：16mm-25mm

Width of plastic steel strip:0.5mm-1.3mm

Packaging and bonding strength: about75%

Biting method: Friction hot melt bonding

Operation method: Pneumatic tension belt friction hot melt type

Using air pressure:0.5-0.7MPA(Normal use in)6kg(Suitable)

MV-19E/MV-25EA brief introduction to pneumatic plastic steel strapping machine:
These two strapping machines are plastic steel strip strapping tools manufactured by Japan Steel Sheet Industry Co., Ltd. They are lightweight pocket sized air tools that can easily complete the entire process from strapping tightening, welding to cutting operations. It can achieve greater tightening force compared to electric tools, and has better performance in reliability and durability.
　　used forPPBringPETPolyester tape and all other thermoplastic resin tape packaging tools are used.

Performance characteristics:
①Lightweight, only3.8kg.
②Equipped with a belt removal device, easy to remove from the belt.
③Equipped with a hanging hook, for suspension by a spring crane.
④Strong tightening force, maximum achievable2800N.
⑤The bonding time, cooling time, and tightening force can all be adjusted.
⑥Specially suitable for packaging circular, curved, and irregularly shaped objects with very small surface areas.
⑦The double bond parallel design of the pull and cut straps allows for one-time tightening, bonding, and cutting, making the operation simple.

Applicable industries: Packaging of various flat or circular objects such as metallurgy, steel, wire, wood, paper, cardboard boxes, etc.

working principle:
1This tool is of the friction hot melt type, which uses high-speed friction to overlap plastic strips and generate heat for bonding, hence it is called friction hot melt.
2Introduce compressed gas into the cylinder piston, which is connected to the upper part of the vibrator by a shaft bolt. The vibrator vibrates back and forth and presses the friction plate together to bond the overlapping part of the binding tape.
3There is an elliptical hole in the middle of the vibrator, where the eccentric shaft of the fan blade motor rotates back and forth.
4The air motor rotates at high speed, reaching its maximum speed10,000rpm,Make the vibrator move at high speed like a pendulum.
5The lower strapping is fixed on the plywood by the triangular teeth of the bottom die; The upper strapping is bonded due to the intense vibration of the triangular teeth of the vibrator and the heat generated by friction with the lower strapping.
6The overlapping part of the strapping is fused at the interface. When the vibration time is up, the machine will automatically stop and the bonding will end.
7When fixing the upper and lower straps under high pressure, wait a few seconds to ensure sufficient cooling of the bonding area.