Product Introduction:

Nitrogen blowing is used for sample preparation in liquid phase, gas phase, and mass spectrometry analysis. It adopts * approved technology to concentrate the sample by blowing nitrogen into the surface of the heated sample. This method has the characteristics of time-saving, easy operation, and easy control, and can quickly obtain the expected results. This technology uses solid-phase extraction pretreatment technology instead of traditional liquid-phase extraction and chromatography techniques, enabling rapid separation and purification of samples. Replacing the commonly used rotary evaporator with nitrogen blowing for concentration greatly shortens the analysis time. The MTN-2800 series nitrogen blowing device produced by our company uses aluminum heating blocks as bathrooms, which have good heat transfer performance, uniform heat transfer, and are conducive to rapid heating and temperature control. Blow nitrogen onto the surface of the sample to achieve anaerobic concentration of the liquid sample. Blow pipes are independent of each other and will not cause cross contamination.

Product features:

The MTN-2800W comes with a test tube rack that allows for easy removal or insertion of test tubes into the sink, and can be fixed at any height.

The dual protection of automatic upper limit temperature protection and temperature deviation protection ensures better use.

3. There are two methods: timed constant temperature or continuous constant temperature.

4. Four sets of digital displays display the set temperature, actual temperature, set timing, and incremental/decremental timing.

5. The internal structural design allows the instrument to operate at a relatively high constant temperature for a long time.

Specification parameters:
Product model: MTN-2800W-12/24/40
Temperature regulation range: room temperature+5 ℃~100 ℃
Temperature regulation accuracy: ± 0.1 ℃
Upper limit temperature protection (℃): 110
Temperature deviation protection (℃): set temperature+5
Timed time: 10 minutes to 99 hours and 59 minutes
Number of holes: 12 holes/24 holes/40 holes
Heating power: 350W
Power supply voltage: 220V/50Hz
Heating block size (mm): 150W × 70H × 95L

Dimensions (excluding pole height mm): 240W x 130H x 215D