IS centrifugal pump

The IS type single-stage single suction (axial suction) centrifugal pump is an energy-saving pump jointly designed by the whole country. It is an updated version of the BA type, B type, and other single-stage clear water centrifugal pumps. Advantages include: reasonable layout of hydraulic performance across the entire series, wide range of user choices, and convenient maintenance; Efficiency and suction reach the international average advanced level. This type of pump is suitable for industrial and urban water supply and drainage, as well as agricultural irrigation and transportation of clean water or other liquids with physical and chemical properties similar to clean water, with a temperature not exceeding 80 ℃.

Product Features
1. The IS series is designed according to the performance and dimensions specified in the international standard ISO2858, mainly consisting of the pump body, pump cover, impeller, shaft, sealing ring, shaft sleeve, and suspension bearings.
2. The pump body and pump cover of the IS type are divided from the back of the impeller, which is commonly known as the rear opening structure. Its advantage is easy maintenance. During maintenance, the pump body, suction pipeline, discharge pipeline, and motor are not moved. Only the middle connecting piece of the extended coupling needs to be removed to exit the rotor part for maintenance.
3. The pump casing (i.e. pump body and pump cover) constitutes the working chamber of the pump. The impeller, shaft, and rolling bearings are the rotors of the pump. The suspension bearing components support the rotor part of the pump, while the rolling bearings are subjected to the radial and axial forces of the pump.
4. In order to balance the axial force of the pump, most pumps are equipped with sealing rings at the front and rear of the impeller, and balance holes are provided on the rear cover plate of the impeller. Due to the low axial force of some pumps, there are no sealing rings or balance holes on the back of the impeller.
5. The axial sealing ring of the pump is composed of a packing gland, packing ring, and packing to prevent air intake or significant water leakage. If the impeller of the pump is balanced, the cavity containing soft packing is connected to the suction port of the impeller. If the liquid at the inlet of the impeller is in a vacuum state, it is easy to introduce air along the surface of the shaft sleeve. Therefore, a packing ring is installed in the packing chamber through the small hole on the pump cover to guide the pressure water in the pump chamber to the packing ring for sealing. If the impeller of the pump does not have a balance hole, there is no leakage problem due to the liquid pressure on the back of the impeller being greater than atmospheric pressure, so the packing ring can be omitted.
6. To avoid shaft wear, a shaft sleeve protection is installed at the part where the shaft passes through the packing chamber. There is an O-ring seal between the shaft sleeve and the shaft to prevent air intake or water leakage along the mating surface.
7. The transmission mode of the pump is connected to the electric motor through an extended elastic coupling, and the rotation direction of the pump is clockwise when viewed from the driving end.

Model meaning
For example: IS80-65-160A
IS single-stage single suction centrifugal pump for clean water
80- Inlet diameter (mm)
65- Discharge outlet diameter (mm)
160- nominal diameter of impeller (mm)
A-impeller cutting mark