The four layer oven is composed of angle steel and thin steel plates. In addition, the box is reinforced and the outer surface is repainted. The space between the outer shell and the inner liner is filled with aluminum silicate fibers to form a reliable insulation layer,Four layer ovenThe application range is very wide, and it can dry various typesproductIt is a universal drying equipment.

1. Adopting the domestically pioneering streamlined arc design, the shell is made of cold-rolled steel plate, and the surface is electrostatically sprayed with plastic;

2. The temperature control system adopts microcomputer microcontroller technology, which has functions such as temperature control, timing, and over temperature alarm

3. Reasonable air ducts and circulation systems to minimize temperature uniformity changes within the workspace;

4. Adopting dual screen high brightness digital display, accurate and intuitive indication, superior performance, and touch button setting adjustment;

5. The inner liner is made of mirror stainless steel material, and the semi-circular four corner design makes cleaning more convenient;

6. The height and quantity of shelves in the studio can be adjusted according to the user's requirements;

7. Adopting imported motors and blades, equipped with air convection and breeze devices, the internal air can be updated and circulated;

Note: The model dimensions in the following table can be replaced with the model dimensions in the above table

Fault handling

·1、 There is no display on the operation panel when the power switch is turned on

·1. Please check if the three-phase power supply and neutral wire are disconnected.

·2. Is the internal switch tripped.

·3. Is the fuse blown? Please replace it with a new one.

·4. Check if the phase sequence of R, S, and T is consistent and if there is a missing phase. Please replace the three-phase power supply.

·2、 Not heated/Slow heating

·1. Please check if the output power is set to zero or low.

·2. Please check the three-phase power supply and neutral wire.

·3. Whether the air supply switch is turned on and whether the direction of the fan is correct.

·3、 Not timed: Please check the timer output parametersIs OUTMODE A-2, otherwise it will not time.

·4、 Not running air: Please check the three-phase power supply, whether the air contactor is engaged, and whether the thermal relay is tripped.

produceProduct installation

·1. Please connect the three-phase power supply and neutral wire correctly.

·2. Turn on the power switch, the power indicator light will turn on, and the voltmeter will indicate 380V voltage.

·3. Turn on the air supply switch, and the air supply motor will start running. There will be strong winds blowing out from the inside of the oven

·Confirm with the three keys and SET key. Adjust the required temperature and heat it up (it is strictly prohibited to not use air supply heating).

·5. Set the timer time, and the 1, 2, 3, and 4 keys on the panel correspond to the individual, ten, hundred, and thousand digits of the displayed value. After modifying the desired time, turn on the timer switch.

·6. Explanation of overtemperature setting: In general, the temperature value set for overtemperature should be between 3-5 ℃ higher than the temperature set by the thermostat. When the temperature exceeds the limit, the overtemperature indicator light will turn on and all heating systems will be turned off, and the air supply will operate normally

·7. After the baking time is up, timer, alarm, and automatic power-off will be triggered.

·8. Temperature controller setting: Temperature setting: The instrument displays the actual temperature inside the furnace, and the SV displays the set temperature. First, press the move button, and the SV display value will flash. Move it to the desired position, ten position, or hundred position. Then press the ▲ up button to increase the temperature, or press the down button to decrease the temperature. Finally, press the SET button to confirm the temperature you have set, and the SV display value will stop flashing.