DJ-1ADigital constant temperature high-power mixerinstructions
1. This mixer adopts a dual row digital display, with a left row four digit digital display showing speed and a right row three digit digital display showing set time. After power on, the speed digital display shows the last set saved value, and the time digital display shows OFF, indicating a normally closed state. The last digit of the two rows of digital tubes is flashing, indicating the set state.
2. There are two buttons below the speed digital display, which can be used to set the speed value up and down respectively. The setting range is 300-3000r/min. Press the button once to move the speed value up or down by 10r/min. Press it for 10 seconds to quickly set it.
3. There are also two buttons below the time digital display, which can be used to set the time value up and down respectively, with a setting range of 0-240min. After powering on, it displays a normally closed state OFF. Pressing the down button once can switch to the normally open state ON, pressing the up button can set the timing value up, and pressing it for 10 seconds can quickly set it.
4. After setting the desired speed and time values, there are two buttons on the right side of the panel. The top button is the start button, and the bottom button is the pause button. Press the start button to start the mixer from low speed, quickly stabilize at the set value in a short time, and start counting down the set time (note: the mixer cannot be started when the set time is OFF)
During the mixing process, except for the pause button, all other buttons cannot function. Pressing the pause button will stop the motor and restore it to the set state. Users can reset the required value.
After pressing the pause button and repeating the button, ZWJ-1B model can be set in 3 stages, each stage can be set with a separate time and speed. After pressing the start button, the program will automatically start executing from stage *.
Note: If only a single segment is required for B-type use, the remaining two segments cannot be set to time values after the time setting of the usage segment is completed, that is, they are in the OFF state.