1It can overcome the shortcomings of 3D software and avoid the tedious process of writing 3D programs. Chamfering can be completed by floating the tool holder up and down along the contour of the undulating workpiece;

2No need to run the Z-axis;

3Save time and reduce mechanical wear;

4Suitable for curved and irregularly shaped workpieces;

5The up and down floating range is completed in one go within 10mm;

The front-end grinding tool can be replaced by customers, with ER11 cylinder clamp and standard clamping range of 6mm spring chuck. You can replace different specifications of grinding heads according to your actual needs, suitable for processing different products. The product allows a rotational speed of 5000-8000rpm, and customers can adjust it according to the different machining centers and materials to achieve the desired machining effect.

The purpose of deburring and chamfering is achieved by continuously squeezing and cutting the edge of the workpiece being processed. The axial floating deburring tool has a floating range of 10mm in the axial direction, which is used to remove contour burrs with height changes or burrs on the surface of the hole. When using, set the Z-axis position of the tool so that the grinding tool touches the surface of the workpiece by 1-2mm (pre pressing amount), and then the tool can automatically compensate in the height direction, thereby achieving the goal of removing burrs on irregular height surfaces.

By using the ER11 chuck, the diameter of the cutting roller blade handle can be clamped from 0.5mm to 7mm;

Has an axial floating range of 10mm;

Compensation capability; Can be raised by 10mm;

Rotate in the same direction as the machining direction;

Clockwise rotation speed: 5000-8000r/min;

Feed rate: F2000-4000mm/min；

Through the floating mechanism of the tool, this floating deburring and chamfering tool can move along the uneven edges of the workpiece for processing. The pressure of the up and down floating can be adjusted through the mechanism inside the tool holder. The tool can be directly driven by the machine tool and machining center spindle or used on a powered robotic arm.

The auxiliary spring inside the tool holder is relatively soft and suitable for processing soft materials. If the required elastic effect cannot be achieved, please replace the hard spring included in the packaging box.

The specifications of the front-end tungsten steel rolling knife are shown in the diagram. If customers need other specifications, they can purchase and replace them themselvesER11-6Specifications, clamping6mmHandle diameter.