Chemical grade dispersing emulsifierEquipment Introduction

Equipment Introduction

Pipeline typeChemical grade dispersing emulsifierIt is a high-performance equipment used for continuous production or cyclic processing of fine materials. Inside a narrow cavity, it is equipped with a set of dual interlocking multi-layer fixed and rotor. When the rotor rotates at high speed, it generates strong axial suction to suck the material into the cavity and start rapid processing. Suitable for working conditions without hygiene requirements, it is widely used in the chemical industry.Pigments, fuels, coatings, paints, plastics, resins, inks, pastes, pastes, hot melt adhesives, flame retardants, adhesives, finishing agents, surfactants, dyeing agents, etcAnti sticking agents, defoamers, brighteners, rubber additives, plastic additives, fuel additives, coagulants, coagulants, surfactants, solvents, silicone oil emulsions, resin emulsions, carbon black dispersions, white carbon black and other industries have application cases.

(For negotiations, please:）

Equipment principle
After entering the equipment cavity, the material is quickly dispersed, emulsified, and homogenized by the stator and rotor, and the particle size distribution range is significantly narrowed, resulting in more uniform mixing of the material.

Equipment advantages
Large processing capacity, suitable for industrial online continuous production
Narrow particle size distribution range and high uniformity
Time saving, efficient, and energy-saving
Low noise, smooth operation
Eliminate quality differences in production between batches
No dead corners, materials are 100% cut through dispersion
Equipped with short distance and low head conveying function, it can achieve cyclic processing
Easy to operate and convenient to maintain
Can achieve automated control

(For negotiations, please:）

Equipment selection table

notes
* The flow range in the table refers to the data measured when the medium is "water", and the outlet pressure of the models listed in the table is ≤ 0.15MPa;
*If using a cyclic process, it is recommended to use it in conjunction with an intermittent high shear dispersing emulsifier;
*If there are special working conditions such as high temperature, high pressure, flammability, explosiveness, corrosion, etc., detailed and accurate parameters must be provided;
*For media with poor fluidity, it is recommended to use a pump with matching flow rate at the inlet for transportation, and the pressure of the conveying pump should be ≤ 0.3MPa;
*The data in this table is subject to change without prior notice, and the correct parameters are based on the actual product provided.