Carbolite AAF 11/3 and AAF 11/7 standard ashing furnaces

1、 Product Introduction:

The Carbolite AAF ashing furnace series is designed for the optimal ashing environment, ensuring complete combustion of samples.

AAF 11/3 and AAF 11/7 ashing furnaces continuously introduce preheated air into the furnace, in accordance with ISO 1171:2010 ASTM D3174-04: 2010 and ASTM D4422 standards.

2、 Standard parameters:

1. Maximum temperature 1100 ° C

2. PID301 standard controller, single segment program control

3. The bottom area of the furnace is large, which can load more samples

4. Suitable for food, plastics, coal, and other hydrocarbons

5. Compliant with standard ISO 1171:2010 ASTM D3174-04: 2010 and ASTM D4422

6. Hard alumina wear-resistant lining to prevent chemical erosion and mechanical impact on heating elements

7. Four sided heating (both sides, top and bottom of the furnace)

8. Air intake and high chimney design to ensure 4-5 air changes per minute

9. Low chimney ensures maximum airflow proximity to the sample, optimizing combustion efficiency

10. Using high-power heating elements to compensate for heat loss caused by high airflow

11. After preheating, the air enters the furnace to ensure good temperature uniformity

12. Sample loading tray and handle

3、 Optional accessories:

1. A series of precision digital controllers with digital communication options, multi-stage programmers and data recorders, as well as digital communication interfaces

2. Over temperature protection (recommended for protecting valuable samples or unattended operations)

3. AAF 11/7 provides two-phase electricity

4、 Technical parameters:

5、 Attention:

1. The insulation power is measured at 500 ° C

2. The heating rate is measured under no-load operation with the temperature set at 100 ° C below the maximum temperature

3. The maximum power and heating time are both based on a 240V power supply