1.B5032EMechanical insertion bed, used forProcessing flat surfaces, forming surfaces, and keyways of various workpieces, suitable for single piece and small batch production.

2Main technical parameters of bed insertion:

3The main structure and characteristics of the insertion bed:

The machine tool is composed of main components such as bed, slider, worktable, feed box, gearbox, and electrical system.

The bed is composed of two parts, upper and lower. The front of the upper bed is equipped with a sliding pillow, sliding frame, and rocker mechanism, and the bottom is cast with a partition as a lubricating oil pool. Oil is delivered to the slide rail and other areas through plunger oil pumps, oil separators, etc. After opening the back cover of the bed, oil can be injected. The oil level is indicated by the front oil gauge. There is a dovetail shaped guide rail above the front of the lower bed for the longitudinal movement of the worktable. An electric motor is installed inside the rear, and a feed box is installed on the right side of the rear.

The slider rocker mechanism is a mechanism that converts the rotational motion of the rocker gear into the reciprocating motion of the slider. According to the height of the workpiece, the slider can be usedFor adjustments within the range of 370mm, the nut in front of the slider can be loosened first, and then the umbrella gear with a square head can be twisted to obtain the vertical displacement of the slider. After meeting the requirements, the nut can still be tightened.

During the return stroke of the slider, the insert tool can rotate around the cone pin at the bottom right of the tool holder to protect the cutting edge of the tool.

The handwheel on the gearbox can be manually rotated to achieve vertical movement of the slider.

The workbench can achieve longitudinal, transverse, or rotary mobile feed; With the help of the overrunning clutch in the feed box, pressing the fast movement jog button on the worktable can achieve rapid movement in the longitudinal, transverse, or rotary directions respectively. The movement amount of each grid of the scale circle is0.05mmThe amount of movement per revolution is6mm.

By turning the reversing handle on the feed box, the feed direction can be changed, and changing the feed amount is achieved by moving the position on the upper scale rocker arm of the feed rod.

By turning the two handles on the gearbox, you can obtain four different reciprocating movements of the slider. Twist the square head at the outer end of the feed drum to obtain the required stroke length according to the scale.

After loosening the nuts on both sides, twist the nuts again, and according to the scale, the slider can be obtained0～8Any tilt position within the range of degrees must be adjusted by tightening the nuts on both sides before driving.

The start and stop of the machine tool are achieved by buttons installed on the side of the bed and the handle on the right side of the gearbox.

This machine tool has a beautiful and elegant appearance, is easy to operate and maintain, and has stable and reliable performance and accuracy.

QLCT fully connected machine tool warm reminder: Due to continuous design improvement, the above machine tool technical parameters are for reference only. If there are any changes in paint color, we will not notify you separately. We apologize for any inconvenience caused and thank you for your cooperation!